Issue with calculation in a box groove #358
ToFFmashines
started this conversation in
General
Replies: 1 comment
|
Hi @ToFFmashines, If you a special kind of rotation, you can have a look at the |
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
Hi everyone,
I am having a problem with a calculation in a box groove.
I prepared a very simple notebook with a minimal example. box_simple_picture.ipynb
It also contains a plot showing the overlap between the incoming material cross-section and the groove geometry, so the geometry can be checked visually.
The calculation fails with:
and also with the warning:
To make the comparison easier, I also added a second calculation where the same incoming profile is rolled in a flat pass with the same height reduction. That calculation is meant only as a reference case.
I tried to search GitHub to see whether this problem had already been reported. The only related issue I found was BoxGroove Issues #308, which seems to show a similar
entry_point/sqrtproblem.Do you have any experience with this kind of error in a box groove calculation?
Is there a recommended way to avoid this situation, or should I define the box groove / incoming profile differently?
Any hints would be appreciated.
Best regards,
Tomáš
All reactions